Takura Steel Buildings

HPCI Barrier

HPCI Barrier

The HPCI Barrier™ insulated metal panel is an air, water, thermal and vapor barrier panel that can be used behind any type of facade. The HPCI Barrier back-up panel is installed in a horizontal orientation completely outside the structural supports. There are no thermal bridges to reduce the energy efficiency of the wall. HPCI Barrier is quick and easy to install and provides an economical solution to conventional air, water, thermal and vapor control without sacrificing thermal efficiency.

Exterior Profile:

No profile embossed

Interior Profile:

Light Mesa embossed

Panel Core:

Foamed-in-place, Non-CFC & zero ODP polyurethane

Thermal Values:

K-factor, Btu in/ft2 hr. °F @ 75°F (24°C) mean core temperature = 0.140

Module Width:

42″

Panel Thickness:

2″, 3″, 4″

Panel Lengths:

8′-0″ to 24′-0″

Exterior Facings:

Minimum .016″ thick HPCI galvanized steel

Interior Facings:

Minimum .016″ thick HPCI galvanized steel

Panel Joint:

Offset double tongue and groove with extended metal shelf for positive face fastening

Fastening:

Fastener and Clip concealed in the side joint Factory caulking available

Finishes & Colors:

White polyester

Oil Canning:

All flat metal surfaces can display waviness commonly referred to as “oil canning.” “Oil canning” is an inherent characteristic of steel products, not a defect, and therefore is not a cause for panel rejection.

Note: The HPCI Barrier Panel must be separated from the interior of the building by an approved thermal barrier of .5″ (12.7mm) gypsum wallboard to meet IBC requirements.

Takura Steel Buildings offers metl-span insulated panels to clients across Ontario, British Columbia, Alberta, Saskatchewan, Manitoba, Quebec, New Brunswick, Newfoundland and Labrador, Yukon, Northwest Territories, and Nunavut.